Over ons
Home  >  Nieuws  >  REDUNDANT LOAD CELLS

Redundant load cells

Terug naar de News

Generally speaking, load cells, load pins, force transducers and torque sensors all have just one measurement channel. Indeed, in most cases, this feature is sufficient for the needed requirements.

However, to improve measurement reliability or to better suit the application, it may be interesting, or even compulsory, to get redundant measurement channels by using several additional Wheatstone bridges to measure the same deformation. 



Here are some examples:

  • Subsea force transducer with long-term inaccessibility with 2 Wheatstone bridges, 2 amplifiers and 2 cables to create a back-up (second) channel in case the first one fails.
  • SIL3 (IEC / EN 61508) certified handling system  including a load pin with 2 amplified Wheatstone bridges (4-20 mA) connected to a safety PLC constantly checking the consistency of both these signals.
  • Load cell with 3 channels: one connected to overload protection electronics, the second to a PLC and the third to a data logger.
  • Torque sensor with an analogue signal (4-20 mA) for connection to a local PLC and a digital signal (RS-485) for connection to a field bus.
  • etc.


Thus, among many available options, SENSY regularly delivers load cells, load pins, force transducers or torque sensors, all with several redundant measuring channels guaranteeing higher safety and reliability levels. This new complex architecture meets the new safety and security requirements required for modern force measurement and control systems.

Sensor customization

Deze pagina werd ontworpen om u te helpen bij het definiëren van uw op maat gemaakte dynamometrische as.


Newsletter en technische documenten
Do you have a project for which you need an advice ?
GMT +1
+32 71 25 82 00
Blijf op de hoogte :
Z.I. de Jumet - Allée Centrale - BE-6040 Jumet - Belgium
BTW n°: BE0427858981 - RPM Charleroi
Tel +32 71 25 82 00 - Fax +32 71 37 09 11
E-mail :
Load cell manufacturer - made in Belgium